Secure the card first
The GPU bracket and case screws stay primary. This support only helps at the free end.
QP-BRACKET-AS setup
Set it. Lock it.
Recheck it.
Seven owner checks. One hard stop.
Supplemental support only. No load rating, universal fit, or safety approval.
The boundary
Retention
Contact
Height
Three rules first.
Use structure only
Use a cooler or backplate surface. Never bare PCB, a connector, cable, fan, or fin.
Use one locked stop
No shims. No forcing. No rail held between holes. Check the nine stops.
Setup
1
2
3
4
5
6
7
Seven plain checks.
Power off
Shut down, unplug, and let the GPU cool before reaching into the case.
Secure the GPU
Install the card bracket and case screws before adding supplemental support.
Place the base
Use a hard, flat floor directly below the intended support point. Print the 58 mm footprint card.
Choose contact
Place the cradle under a structural cooler or backplate surface only.
Set the height
Align one indexed stop. Do not shim, space, force, lift, or bow the card.
Lock the rail
Install the bolt and nut through aligned holes. The rail must not slide.
Check stability
The base sits flat. The support does not rock. Cables and fans stay clear.
Before normal use
Seven checks. One stop.
Local. Nothing saved. Owner record only.
Run it again
Any move resets the check.
Recheck after moving the case, removing or reseating the GPU, or changing the support height or contact point.
Stop for movement.
If the base walks, the rail slides, the cradle shifts, or the card lifts or bows, power off and reset the support. Do not add a shim or force the height.
Something off?
Message Quarkpad on eBay Stop. Send one photo.
For an existing order, keep the installation photo and help request inside eBay Messages.