Two-piece support
A square base carries the indexed rail. The upper cradle slides to the contact height.
Real part. Printed here.
Tall card.
Solid footing.
Measure first. Set the height. Lock the bolt. Support the free end of a horizontally mounted GPU from the case floor.
$22.99Current listing terms and availability on eBay
Check the height
Before eBay
Measure once.
Measure once.
Stop guessing.
Nine CAD stops. No shims. No forcing.
Planning only. Not physical fit or load proof. Print base card.
Bolt and nut
Pick a hole, install the supplied locking hardware, and check that the support cannot move.
Black PC FR
Visible layer lines and small print variations are normal. The photos show the real surface finish.
Measure the gap
You need a direct case-floor path and the nominal 58 mm base square below a safe structural contact point. Print the footprint.
From the bench
One part. Every angle.
These are photographs of the physical printed support. The backgrounds and lighting were standardized for a consistent catalog.
Use boundary
This is support hardware, not the GPU's primary retention. No load rating, universal fit, or temperature claim is made from these photos.
Before or after
Measure. Set. Recheck.
Unsure before ordering? Send the height and an inside-case photo. Part arrived? Run the seven setup checks.