Exact card. Exact revision.
Hard stops.

Check one V100 PG500-216 R3 with the board and fan unpowered. Record what happened. Nothing uploads.

Start the check Read the fixed standard

Owner record only. Quarkpad must review the receipt and four covered photos before changing fit status.

PG500-216 R3 only

Fit. Remove. Repeat.

Stop on force, scrape, movement, blocked hardware, or a fan that will not sit flat.

Exact targetPG500-216

699-2G500-0216-400. R3. PC FR. No nearby V100 substitute.

Measured card and room

Card-end height mm Card-end thickness mm Available free length mm Install and remove cycles

Covered label shows PG500-216 and 699-2G500-0216-400 The tested shroud is marked R3 The board and fan stayed unpowered for this physical check

Confirm only what you observed Seats fully on the cooler rails Stays retained after the clamps are snug Keeps the 8-pin connector and cable path clear Keeps the card intake open Lets the 120 mm fan mount flat

Four photos ready Covered board label Full installed view Seated interface Connector and cable path Serial numbers are covered

Mark every stop observed Force was needed Scraping or rocking appeared A crack or loose feature appeared The connector or cable path was blocked The intake was blocked The fan did not mount flat The shroud moved after the clamps were snug

This page does not operate the GPU, fan, or power supply.

After the check

Receipt plus four photos.

Copy

Keep the fixed receipt unchanged.

Cover

Hide serial numbers and personal details.

Send

Reply through the original order message with all four views.

Review

Quarkpad records a pass or failure. An owner receipt never changes the listing by itself.

Exact card. Exact revision.Hard stops.